2025 Mazda CX-70 powertrain problems

This Service Alert supersedes the previously issued SA listed below: The changes are noted in Red. SA-011/24 02/12/24, 06/06/24, 07/29/24 DESCRIPTION Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers. SCHEDULED MAINTENANCE Refer to the applicable Workshop Manual or Owner's Manual for vehicle -specific manufacturer scheduled maintenance.

2024-2026 CX-90 and 2025-2026 CX-70 Engine Warning Light Illumination with DTC P0DAB CONDITION OF CONCERN On certain subject vehicles, the engine warning light may illuminate, and the vehicle may be limited to engine-only operation due to activation of the fail-safe mode. Motor assist, i-stop and motor regenerative functions may be disabled, although the vehicle is safe to drive. The DTC P0DAB (Cell voltage variation malfunction) may be stored. Causal factor: Improper software in the Powertrain Control Module (PCM) and - MHB in MDARS display - BECM (Battery Energy Control Module). OUTLINE OF REPAIR Reprogram the PCM and MHB with the Mazda Modular Diagnostic System (M-MDS), using Mazda Diagno

The 7G large platform utilizes a new 8-speed automatic transmission. Due to changes in the parking lock mechanism, which is now hydraulically operated, the neutral range in the transmission can only be achieved if the engine is running (or “Ready-On” for PHEV). With this design, there is no provision to manually engage neutral. This can cause challenges to dealers, customers, or towing providers when a vehicle cannot start and can't move, usually due to a discharged (dead) battery. In the event that a vehicle cannot be started or achieve “ready-on”, wheel dollies must be used to allow the vehicle to be rolled and moved. NOTE: The following procedure is for moving vehicle around the service s

When inspected, the differential or PTO oil is dark or black. This is considered normal and NO repair should be performed. During production, differential ring and pinion gears receive a manganese phosphate coating (commonly referred to as black oxide). This coating forms a porous, oil-retentive surface that improves boundary lubrication and reduces adhesive wear during initial contact cycles. Designed as a sacrificial layer, it is gradually removed under load throughout the break-in process. As a result, after the first few hundred miles, or at the initial gear oil service interval, the lubricant may appear darkened by the worn-off coating. It will contain trace ferrous particles from the n

A New Automatic Transmission Fluid (ATF-A7) is being used for some 2023-2026 models. ATF-A7 is an extremely low viscosity formulation with low friction to achieve best-in-class fuel economy and driving performance. For easy identification, ATF-A7 is colored Red and ATF-FZ is colored Blue. ATF-A7 includes UV-reactive dye (see "Fluorescence Example" below). There is NO interchangeability between ATF-A7 and ATF-FZ. For CX-30, Mazda3, and CX-5, some 2.5L and all 2.5T engines still use ATF-FZ. Verify the type of ATF according to what is in MGSS (TRANSMISSION/TRANSAXLE TECHNICAL DATA) or what is marked on the dipstick (see "ATF-A7 Identification" below).