Check any vehicle by VIN

Free. Instant. No signup. Pulls recalls and complaints for your exact vehicle.

Couldn't find that VIN. Check the digits and try again.

ProblemsByVin Checklist / 2010-HONDA-ELEMENT

Pre-purchase · Buyer's checklist

2010 Honda Element inspection checklist

The 2010 Honda Element has 30 owner complaints with NHTSA across 4 component categories. Use this checklist before you put money down — every item below is grounded in the actual failure pattern on this vehicle, not generic advice.

1 Inspect the airbags

What to look for: Anything that looks, sounds, or smells different from peer vehicles of the same year and trim. (6 owner complaints on this vehicle · typical repair $1,100 · failures cluster ~53,700 mi)

Walk around and note any visible damage, wear, or aftermarket modifications
Open the hood and look for fresh fluid leaks, loose connectors, or recent part swaps
Sit in every seat and operate every control to confirm function

See full airbags report for this vehicle →

2 Inspect the suspension

What to look for: Bouncing after bumps, knocking over potholes, sagging on one corner, harsh ride with all the dampening gone. (5 owner complaints on this vehicle · typical repair $900 )

Bounce test — push down hard on each corner of the car; it should rebound once and settle, not bounce
Visible struts/shocks behind the wheels for oil leaks
Sway bar end links and bushings (common wear item, $40–$120 to fix)
Ride height — measure wheel-well to ground at all four corners; uneven = bad spring

On the test drive: Drive over a series of bumps or a railroad crossing — clunks point to worn end links, ball joints, or strut mounts.

See full suspension report for this vehicle →

3 Inspect the brakes

What to look for: Pulsing brake pedal, pulling to one side when braking, squealing or grinding, soft pedal that goes to the floor. (3 owner complaints on this vehicle · typical repair $450 · failures cluster ~37,637 mi)

Brake pad thickness (look through the wheel spokes — at least 4mm material)
Rotor surface — deep grooves or lip on the outer edge means resurface or replace
Brake fluid color in the reservoir — should be light amber, not dark brown
ABS warning light cycles off after start

On the test drive: Hard brake from 40 mph in a safe spot — pedal should be firm, stop should be straight. A pulse means warped rotors ($300–$600).

See full brakes report for this vehicle →

4 Inspect the visibility

What to look for: Wiper streaks even on a fresh blade, blower fan that doesn't change speeds, foggy or yellowed headlight lenses, sunroof drains plugged (water on headliner). (3 owner complaints on this vehicle · typical repair $350 · failures cluster ~6,000 mi)

All wiper speeds front and rear (if equipped) plus washer fluid spray pattern
Defroster — front and rear, every grid line working on the rear glass
HVAC fan on every setting, plus mode (vent, floor, defrost) selector
Sunroof open/close and tilt — check for grinding noises

See full visibility report for this vehicle →

5 Paperwork — before you sign

The seller's transparency on these tells you what kind of seller you're dealing with.

Title in seller's name (not "open title" or "signed by previous owner")
Service records — at least the last 24 months
VIN on the dash matches the door jamb sticker and the title
Run a paid vehicle history report (Carfax or AutoCheck) — accident, salvage, odometer rollback
Confirm any open recalls have been completed (NHTSA VIN lookup)
If financing, get the rate in writing before you set foot on the lot

Inspection items derived from 30 owner complaints and 1 active recall campaigns filed with NHTSA on the 2010 Honda Element. Category-specific guidance is written by ProblemsByVin contributors with ASE-certified mechanic review. This checklist is meant to surface known patterns — it doesn't replace a paid pre-purchase inspection by a qualified shop, which we recommend for any used vehicle priced over a few thousand dollars.