Check any vehicle by VIN

Free. Instant. No signup. Pulls recalls and complaints for your exact vehicle.

Couldn't find that VIN. Check the digits and try again.

ProblemsByVin Checklist / 2010-SUBARU-OUTBACK

Pre-purchase · Buyer's checklist

2010 Subaru Outback inspection checklist

The 2010 Subaru Outback has 359 owner complaints with NHTSA across 6 component categories. Use this checklist before you put money down — every item below is grounded in the actual failure pattern on this vehicle, not generic advice.

1 Inspect the powertrain

What to look for: Hesitation on takeoff, harsh or delayed shifts, vibration at highway speed, fluid leaks on the driveway under the engine bay or transmission pan. (86 owner complaints on this vehicle · typical repair $2,500 · failures cluster ~98,644 mi)

Transmission fluid color and smell — fresh ATF is red, brown or burnt smell is bad
Engine and transmission mounts (cracks or visible sag)
CV boots front (and rear on AWD) — any tears mean a $300–$800 axle replacement
Driveshaft U-joints and rear differential fluid level on RWD/AWD

On the test drive: Drive 15+ minutes including a freeway on-ramp at full throttle, a steep hill, and stop-and-go traffic. Listen for clunks on shifts, flares between gears, and shudders during light acceleration at 30–50 mph (torque converter symptom).

See full powertrain report for this vehicle →

2 Inspect the engine

What to look for: Blue smoke on cold start (oil burning), white smoke at temperature (coolant), knock or tick that doesn't go away after warm-up, oil spots under the vehicle. (44 owner complaints on this vehicle · typical repair $3,100 · failures cluster ~58,173 mi)

Oil dipstick — level on the full mark, color amber not black, no milky residue (head gasket sign)
Coolant reservoir — level, no oil film floating, no rust
Spark plug wells (look down with a flashlight) — oil pooled means valve cover gasket
Timing chain or belt service history (interference engines = $1,500+ if it breaks)
Exhaust smoke briefly after a long idle then a rev

On the test drive: Drive until the gauge reaches operating temp, then check temp stability under load on a hill. Surging or temp climbing under load = thermostat or water pump.

See full engine report for this vehicle →

3 Inspect the airbags

What to look for: Anything that looks, sounds, or smells different from peer vehicles of the same year and trim. (42 owner complaints on this vehicle · typical repair $1,100 · failures cluster ~39,985 mi)

Walk around and note any visible damage, wear, or aftermarket modifications
Open the hood and look for fresh fluid leaks, loose connectors, or recent part swaps
Sit in every seat and operate every control to confirm function

See full airbags report for this vehicle →

4 Inspect the steering

What to look for: Wandering on the highway, clunks when turning, slop in the wheel before the tires respond, power steering whine. (41 owner complaints on this vehicle · typical repair $700 · failures cluster ~33,114 mi)

Tire wear pattern — uneven wear across the tread means alignment or worn suspension
Power steering fluid level (where applicable — most newer vehicles are electric)
Tie rod boots and ball joint boots for tears
Steering wheel free play — should be less than 1 inch at the rim

On the test drive: On a smooth highway, take hands off briefly (when safe) — vehicle should track straight. Pulling left or right means alignment or worn front-end parts.

See full steering report for this vehicle →

5 Inspect the lighting

What to look for: Headlight lens haze that'll need restoration, dim low beams, condensation inside the housings, blinkers flashing fast (bulb out). (28 owner complaints on this vehicle · typical repair $250 · failures cluster ~63,528 mi)

Every exterior light — walk around with a helper pressing the brake, blinkers, hazards
Headlight aim — should not blind oncoming traffic; misaligned often after collision
Interior dome lights, glove box, vanity mirror lights, trunk light

See full lighting report for this vehicle →

6 Inspect the brakes

What to look for: Pulsing brake pedal, pulling to one side when braking, squealing or grinding, soft pedal that goes to the floor. (27 owner complaints on this vehicle · typical repair $450 · failures cluster ~147,960 mi)

Brake pad thickness (look through the wheel spokes — at least 4mm material)
Rotor surface — deep grooves or lip on the outer edge means resurface or replace
Brake fluid color in the reservoir — should be light amber, not dark brown
ABS warning light cycles off after start

On the test drive: Hard brake from 40 mph in a safe spot — pedal should be firm, stop should be straight. A pulse means warped rotors ($300–$600).

See full brakes report for this vehicle →

7 Paperwork — before you sign

The seller's transparency on these tells you what kind of seller you're dealing with.

Title in seller's name (not "open title" or "signed by previous owner")
Service records — at least the last 24 months
VIN on the dash matches the door jamb sticker and the title
Run a paid vehicle history report (Carfax or AutoCheck) — accident, salvage, odometer rollback
Confirm any open recalls have been completed (NHTSA VIN lookup)
If financing, get the rate in writing before you set foot on the lot

Inspection items derived from 359 owner complaints and 0 active recall campaigns filed with NHTSA on the 2010 Subaru Outback. Category-specific guidance is written by ProblemsByVin contributors with ASE-certified mechanic review. This checklist is meant to surface known patterns — it doesn't replace a paid pre-purchase inspection by a qualified shop, which we recommend for any used vehicle priced over a few thousand dollars.

Get a free warranty quote →

Sponsored — we earn a commission if you complete a quote. Disclosure.