The Dynamic Stability Control (DSC) warning light comes on while driving. The following DSC fault codes for the wheel speed sensors are stored: 480712 and/or 480715 and/or 480718 and/or 48071B They cannot be cleared, even though the wheel speed sensors work correctly and no problem can be found with the wiring harness.
full bulletin at NHTSA ↗2011 BMW 550i wheels problems
moderate Owners of the 2011 BMW 550i have filed 5 NHTSA complaints about the wheels at roughly $400 to repair (U.S. federal records, as of July 2026). Source: NHTSA Office of Defects Investigation. See wheels across all vehicles →
Complaints
5
Recalls
0
Avg fix
$400
Is there a fix? Manufacturer service bulletins
The manufacturer has issued service bulletins covering wheels on this vehicle — documented repair instructions, service campaigns, or warranty extensions sent to dealers. A TSB isn't a recall (it's not a free safety remedy), but it's the manufacturer acknowledging the issue and how to fix it.
TICKING NOISE FROM THE FRONT AXLE WHEN CORNERING: The customer may complain of a metallic ticking noise from the front axle, when cornering, maneuvering, parking or pulling away from a parking space.
full bulletin at NHTSA ↗TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: Ticking noise coming from front wheel while cornering without brakes applied, noticeable at low speeds. The vehicle must be moving.
full bulletin at NHTSA ↗TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: This Service Information Bulletin (Revision 3) replaces SI B34 05 17 dated September 2017. Ticking noise coming from front wheel while cornering without brakes applied noticeable at low speeds. The vehicle must be moving. See attached video V34 01 20 Note: For a similar noise heard when parking with the brakes applied refer to SIB 31 01 12. Microscopic movement of the contact interface between the inner brake disc and the wheel bearing flange on vehicles equipped with lightweight brake discs.
full bulletin at NHTSA ↗CRACKING NOISES FROM THE FRONT AXLE AREA WHILE TURNING THE WHEELS, WHEN STATIONARY OR PARKING
full bulletin at NHTSA ↗Source: NHTSA manufacturer communications. Bring the bulletin number to your dealer or shop.
What owners are reporting 0 most recent
Had wheels trouble with your 2011 BMW 550i?
File a complaint with NHTSA → It's free, official, and how every report above got here — owner filings are the federal safety record this page is built on.
Common questions
How serious is the wheels problem on the 2011 BMW 550i?
It's a documented issue but not catastrophic. 5 complaints have been filed. Repairs average $400 and most owners catch it before it causes a breakdown.
At what mileage does the wheels typically fail?
Based on the 5 complaints filed, wheels issues most often appear around 25,058 miles. Some report problems earlier; some make it well past 150,000 with no symptoms. Maintenance habits matter — vehicles that received timely fluid services and were not regularly overworked tend to last longer.
What does it cost to fix?
Independent shops typically charge around $400 for wheels repairs on this vehicle. Dealer pricing tends to run 20-40% higher. The exact figure depends on the specific failure mode, parts availability, and your local labor rates. If you're outside factory warranty, an extended service contract often covers this category.
Are there any recalls related to wheels?
No active recalls currently cover wheels issues on this vehicle. The complaints filed represent owner-reported failures that haven't risen to the level of a manufacturer-issued recall — but they're still worth knowing about before you buy or budget for repairs.
Related
Complaint and recall data sourced from the National Highway Traffic Safety Administration (NHTSA)
public records database. Verify the raw federal record at
nhtsa.gov/vehicle/2011/BMW/550i.
Severity ratings are derived from reported crashes, fires, injuries, and fatalities. Repair cost estimates are
independent-shop national averages and may differ in your area. Some links on this page are affiliate links.