This article supersedes TSB 22-2219 to update the Parts List and Service Procedure to clarify applicable steps by vehicle application. Some 2003-2020 Expedition/Navigator and 2006-2020 F-150 (non-Raptor) vehicles equipped with 4WD may exhibit grinding/clicking/ratcheting noise from the front wheel area. This may be due to partial engagement of the integrated wheel ends (IWE). To correct this condition, follow the Service Procedure to remove and cap the vacuum supply line or to reprogram the transfer case control module (TCCM) and replace any worn vacuum and/or IWE components.
full bulletin at NHTSA ↗2016 Ford Expedition wheels problems
moderate 3 complaints filed with NHTSA · avg repair $400 · see wheels across all vehicles →
Of the 4 model years of Ford Expedition we track for wheels problems, this one has the fewest owner complaints on file (3).
Is there a fix? Manufacturer service bulletins
The manufacturer has issued service bulletins covering wheels on this vehicle — documented repair instructions, service campaigns, or warranty extensions sent to dealers. A TSB isn't a recall (it's not a free safety remedy), but it's the manufacturer acknowledging the issue and how to fix it.
Some 2003-2020 Expedition/Navigator and 2006-2020 F-150 vehicles equipped with TOD transfer cases may exhibit grinding/clicking/ratcheting noise from the front wheel area. This may be due to partial engagement of the integrated wheel ends (IWE). To correct this condition, follow the Service Procedure steps to remove and cap the vacuum supply line.
full bulletin at NHTSA ↗Some 2013-2018 F-150/Expedition/Navigator vehicles equipped with 4-wheel drive (4WD) may exhibit an intermittent grinding noise while driving in 2-wheel drive (2WD) mode most commonly on acceleration. This may be due to a loss of vacuum to the integrated wheel end (IWE) actuators and/or wear of the IWE components. To correct the condition, follow the Service Procedure steps to reprogram the transfer case control module (TCCM) and replace any worn vacuum and/or IWE components.
full bulletin at NHTSA ↗Some 2013-2018 F-150/Expedition/Navigator 4x4 vehicles may exhibit an intermittent grinding noise coming from the right front or left front wheel area while accelerating in 2WD mode. Refer to the Workshop Manual (WSM), Section 308-07, Diagnosis and Testing Symptom Chart - NVH > The front axle makes noise in 2H mode only and generally under heavy throttle.
full bulletin at NHTSA ↗Source: NHTSA manufacturer communications. Bring the bulletin number to your dealer or shop.
What owners are reporting 0 most recent
Common questions
How serious is the wheels problem on the 2016 Ford Expedition?
It's a documented issue but not catastrophic. 3 complaints have been filed. Repairs average $400 and most owners catch it before it causes a breakdown.
At what mileage does the wheels typically fail?
Mileage data is limited for this issue. Owners report failures across a wide range, suggesting cause is more about driving conditions and maintenance than mileage alone.
What does it cost to fix?
Independent shops typically charge around $400 for wheels repairs on this vehicle. Dealer pricing tends to run 20-40% higher. The exact figure depends on the specific failure mode, parts availability, and your local labor rates. If you're outside factory warranty, an extended service contract often covers this category.
Are there any recalls related to wheels?
No active recalls currently cover wheels issues on this vehicle. The complaints filed represent owner-reported failures that haven't risen to the level of a manufacturer-issued recall — but they're still worth knowing about before you buy or budget for repairs.