Free. Instant. No signup. Pulls recalls and complaints for your exact vehicle.
Couldn't find that VIN. Check the digits and try again.
ProblemsByVinRecalls / 2019-SUBARU-ASCENT
3 active campaigns
2019 Subaru Ascent recalls
Every active NHTSA recall campaign for this vehicle, ranked by severity. Each entry shows the consequence
if left unfixed and the manufacturer's prescribed remedy.
0
Critical
3
Severe
0
Moderate
Recall timeline
When were recalls issued for the 2019 Subaru Ascent? Recalls span 2018 to 2019. No new campaigns in over five years — issues appear settled.
1
18
2
19
Critical Severe Moderate
Embed this recall timeline
Free to use on your site, post, or video — just keep the "Source" credit line below the chart. Preview the widget →
If the front end of the driveshaft separates, it can increase the risk of a crash.
Fix: Subaru will notify owners, and dealers will replace the driveshaft assembly, including the center support brace, free of charge. The recall began July 26, 2019. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WUI-94.
If the fluid pressure is measured higher than its actual value, the hydraulic pressure will be reduced. If this occurs, the transmission drive chain may not have the proper tension, resulting in a loss of drive power and an increased risk of a crash.
Fix: Subaru will notify owners, and dealers will reprogram the transmission control unit. The hydraulic sensor harness will be replaced on vehicles with certain stored diagnostic trouble codes. In addition, any vehicle confirmed to have experienced low drive chain tension will have the transmission assembly will be replaced. All repairs will be free of charge. The recall began January 31, 2020. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WUV-07.
In the event of a crash, the missing spot welds may compromise the vehicle's strength, increasing the risk of injury.
Fix: Subaru will notify owners, and dealers will inspect the vehicle to check for missing spot welds. If the welds are missing, the vehicle will be replaced, free of charge. The recall began July 31, 2018. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WTU-80.
Recall data sourced from the NHTSA recallsByVehicle public API. Each campaign number above links to the
official federal record; you can also verify the full recall history at
nhtsa.gov/vehicle/2019/Subaru/Ascent.
Campaign numbers, consequences, and remedies are reproduced from the official record. Manufacturers are
required to provide the remedy free of charge for safety recalls — contact your nearest dealer with the
campaign number to schedule the repair.