2020 Ford F-350 owner complaints

The contact owns a 2020 Ford F-350. The contact stated that while attempting to reverse the vehicle, the engine revved but the vehicle would not move. The power train malfunction warning light illuminated. The vehicle was taken to the dealer and diagnosed with number one planetary and ring gear assembly failure. The number one planetary and ring gear assembly needed to be replaced. The vehicle was not repaired. Upon investigation, the contact related the failure to Customer Satisfaction Program: 21B03 (Number One Planetary and Ring Gear Assembly) however, the dealer informed the contact that the VIN was not included in the program. The manufacturer was made aware of the failure and referred the contact to file a complaint with NHTSA. The failure mileage was approximately 163,000.

The transmission slips and hard shifts. I honestly believe the dealership knew and sold it to us knowing since we found out afterwards it's a known issue and in the bulletin about the truck.

The contact owns a 2020 Ford F-350. The contact stated while driving 55 MPH, the vehicle unintendedly downshifted and the vehicle lost motive power. After the failure, the vehicle went into LIMP Mode and stalled. The contact stated that the check engine warning light was illuminated. The vehicle was taken to the dealer, who diagnosed a failure with the transmission. The vehicle was not repaired. After investigating the failure, the contact related the failure to Customer Satisfaction Program 21B03. The manufacturer was notified of the failure, and a case was opened. The failure mileage was 75,000.

2020 Ford f-350. Consumer writes in regard to transmission issues. The gears were slipping and the engine was revving without stepping on the gas pedal.

The contact owns a 2020 Ford F-350. The contact received notification of NHTSA Campaign Number: 21V536000 (Power Train). The contact took the vehicle to local dealer but was not able to complete the recall due to not having and employee to weld the axle. The contact was not content with welding the axle. The manufacturer was made aware of the issue. The contact had not experienced a failure.

Tl* the contact owns a 2020 Ford f-350. The contact stated that the transmission and torque converter were replaced five times within the last 9,000 miles. The vehicle was taken to caruso Ford Lincoln (3500 cherry ave, long beach, ca 90807; (562) 426-3301) where all the repairs were made however, the failure persisted. The manufacturer was made aware of the failure and a case was filed. The approximate failure mileage was 37,000.

On 3 occasions since I bought the pu new on july 24th, 2020 I experienced what the Ford dealer now calls death wobble. The first time happened on sept 2nd while driving down hill pulling my trailer at about 50mph. When I stepped on the brake the steering wheel and brake pedal started to shake violently. I had little control until my speed dropped. I took the pu to the dealer sept 16th. They said they could find no problem and stated if their agent could not experience the problem while driving the pu they could not fix it. On the second time I was driving the pu empty at highway speed and again while braking the steering and brakes shook violently. Up to this point I was thinking the brakes were the problem. I started tracking the brake temperature which showed a large variety of temps for

This has occured multiple times. While driving on freeway at speeds between 65 and 75 MPH and hitting rough asphalt, the vehicle begins shaking violently, almost to the point of losing control. It will only stop if I slow down to under 40 mph or stopping altogether. This has been very frightening when it occurs in traffic on freeways. It seems to occur mainly when on a curve.

Repeated “death wobble” where the steering components oscillate rapidly left and right causing a lack of steering control. One repair attempted. Later occurrence and another repair. A third event, this time while pulling a 14,000 pound 5th wheel trailer. At about 63 mph the wobble started. I braked, the truck pulled left and I could not maintain my lane. An 18-wheeler behind me moved to the left lane due to my braking and we almost collided due to my not being able to steer. I did get it under control to get back in my lane and avoid the collision. This has been worked on by two different dealers and is about to be looked at again by the original dealer. Almost every front-end component has already been replaced.

Brought this truck on november 5,2020. It is a Ford f-350 super duty dually . On november 25,2020 the power steering went out couldn't steer truck then within a few mins. Lost the brakes on the truck. Had to hold brakes to floor to get truck stopped beside of road. Look like lost fluid from power steering . Was a good thing on a two lane road with little traffic. Was about to get on interstate highway where this would have been bad with all that traffic and going speed limit . Why would brakes go out if power steering quit?

While traveling to and from New Orleans from New Jersey I had 12 incidents of the Ford Death Wobble. The first time I was traveling at 70 mile per hour when I hit a bump in the road and the wobble started. I was able to slow to about 30 miles per hour and the wobble stopped. Over the 2500 miles traveled I experienced this wobble at speeds as slow as 55 miles per hour. I will be taking my vehicle to the Ford dealer I purchased it from to see if they can help. Right now I am afraid to drive faster that 55 mile per hours for fear I my hit some kind of bump that will start this wobble and cause me to loose control of my truck.

The contact owns a 2020 Ford F-350. The contact stated while starting the vehicle, the rearview camera became inoperable. The contact stated that the rearview camera image did not display properly and was very blurry. The vehicle was taken to an independent mechanic where it was diagnosed that the printed circuit board for the backup camera failed and needed to be replaced. The dealer was contacted. The vehicle was not diagnosed or repaired. The dealer referred the contact to the manufacturer for assistance. The manufacturer was made aware of the failure and referred the contact to the NHSTA Hotline for assistance. The approximate failure mileage was 146,913.

The contact owns a 2020 Ford F-350. The contact stated that when the front passenger’s side door was locked, the door could not be opened from outside the vehicle. The contact state that the door could only be unlocked by using the interior door lock mechanism. The vehicle was taken to the local dealer who was unable to duplicate the failure. After retrieving the vehicle, the failure continued to occur. The contact was later informed by the dealer that the door actuator was likely the cause of the failure and needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure, but no assistance was offered. The failure mileage was 34,000.

Truck's power door lock actuators are failing and fail to unlock the doors via remote or the interior door(s) electric unlock button(s). The only way to open the door is via exterior key (if you happen to have it accessible) or if you pull the vehicle's interior door handle, which then "pops" the door lock button. This failure is alarming as in the event of an emergency, access to the interior cab of the vehicle can not be gained from the exterior without a key. Similarly, access to the interior of the cab can only be provided when one squeezes, or pulls, the vehicle's interior door handle. If a driver/passenger is incapacitated for some emergent reason, there is no easy way to gain rapid access to the passenger compartment without extrication type equipment. From my on-line research it ap

Brought a new Ford super duty f-350 dually on november 5,2020. On november 6 2020, the passenger door caught behind the front fender, causing the passenger to not be able to open door. When we got door open , notice that the passenger door was out of line and had dropped down. The front fender was out of line with the door and hood. When door stuck it caused a dent in door and fender also chipped paint off. The issue is if passenger had to exit door in emergency without a lot of force it may not open properly or fast enough because of body parts way out of line. If a person was trying to open door from outside and it hung it could cause that person to loose grip of door suddenly and make them fall to ground causing injuries to them. Truck was not in motion when this occurred and parked in

The contact owns a 2020 Ford F-350. The contact stated that while driving at an undisclosed speed, the engine power failure warning light illuminated, and the engine seized. The contact stated that the failure had occurred while towing a small vehicle. The contact coasted the vehicle to the shoulder of the road, which was very unsafe. The contact stated that while attempting to restart the vehicle, the vehicle failed to restart. The vehicle was towed to an independent mechanic, where it was diagnosed with high-pressure fuel pump failure, cylinder rod and head gasket failures. The contact was informed that the high-pressure fuel pump had exploded and sent fuel all over and into the engine. The contact was informed that the engine had failed due to a high-pressure fuel pump failure. The cont

The contact owns a 2020 Ford F-350. The contact received notification of NHTSA Campaign Number: 24V957000 (Fuel System, Diesel); however, the part for the recall repair was not available. The contact stated that parts were still not available for approximately one year. The contact stated it should not take the manufacturer that long to write a new software program. In addition, the contact stated that the vehicle was purchased and used for recreational purposes. The dealer was contacted several times. The contact stated that on the last conversation with the dealer, the contact was informed that parts should be available in several months; however, parts were still unavailable. The manufacturer was contacted. The contact had not experienced a failure.

In 2020 I Purchased Meyer Products Night Saber 4 LED Headlights for my snowplow. I thought they would be better than Meyers Nite Blaster 2 Halogen Headlights. Which I have found not to be the case. The Lens Defroster does not work well in heavy snow. They do not stay on constantly to keep melting snow off of the lens. Which becomes heavly snow laden severely impacting driving visibility. On more than one occasion I have had to pull over and manually clean the snow build up off of the lens. The most recent was the evening of Thursday [XXX] in which Maine had a heavy wet snow fall in Penobscot & Waldo County area. I had called Meyer Products in the past to complain about the the heater grid issue of not being able to keep up with keeping the lens clear & free of snow build up. I have

right side headlight always had condensation and much more condensation than the left side, however, Ford and dealer always said that it was for ventilation. after a rain, the right headlight light was always on, even when the car was off, and after that the right signal and lamp will not turn on anymore. Dealer did changed the whole headlight assembly, however, the issue still there.

I have the 7.3 gas engine. It is now sounding like a typewriter. I've been told I could have a $8,000 to $13,000 repair or total engine replacement. My truck is just under 97,000 miles and this has been a known issue for the Job 1 engines. Ford is not taking ownership of these lifter/cam issue. I was told I could have my engine lock up on me while driving. I am autistic and have an autoimmune issue that cause me to have a disabilities. It does not seem right, that a long term, multiple Ford owner now could have their engine fail or lock up while I'm driving, not to mention I may need a complete new engine from this design error. From what I've read, the Job 2 of these engines they've enlarged oil recyclers or something to correct this issue. Can you help us that have this major saftey issu