Free. Instant. No signup. Pulls recalls and complaints for your exact vehicle.
Couldn't find that VIN. Check the digits and try again.
severe 5 complaints filed with NHTSA · avg repair $700 · see steering across all vehicles →
Of the 11 model years of RAM 1500 we track for steering problems, this one has the fewest owner complaints on file (5).
Turn signals that do not function properly may fail to indicate the driver's intention to change vehicle direction, increasing the risk of a crash.
The manufacturer has issued service bulletins covering steering on this vehicle — documented repair instructions, service campaigns, or warranty extensions sent to dealers. A TSB isn't a recall (it's not a free safety remedy), but it's the manufacturer acknowledging the issue and how to fix it.
Diagnostic Trouble Code (DTC) C221F-00, C2223-00, C221C-00, C0051-54 Present After Electric Power Steering (EPS) Replacement.
full bulletin at NHTSA ↗Steering Repair Information Involving Toe Angle. Tie Rod And Or Electric Power Steering (EPS) Units.
full bulletin at NHTSA ↗MODULE Steering Control Before replacing the steering column control module (SCCM) due to turn signal inop, wipers inop, steering controls inop, TCS light DTC C0051 or horn blowing while turning, please follow these steps: 1.- Refer to service library procedure and follow diagnosis steps. 2.- If failure still present, make sure all the switches', horn's, airbag's harness are properly connected and there is no corrosion or pinching, disconnect the switches & reconnect them, and reverify the issue. 3.- Verify if failure is still present, review if there is lack of communication between SCCM and BCM. For example, activate turn signals or wipers. 4.- Read at the BCM diagnosis session if BCM is r
full bulletin at NHTSA ↗MODULE Steering Control Before replacing the steering column control module (SCCM), please follow these steps: 1.- Make sure all the switches' and airbag's harness are properly connected, disconnect the switches and reconnect them, and reverify the issue. 2.- Pull the SCCM fuse for 60 sec and then reinstall it. 3.- Reverify if Steering wheel switches are inoperative. If there are no DTC's, physical defects, nor switches inop, then SCCM does not need to be replaced.
full bulletin at NHTSA ↗SWITCH Multifunction Before replacing the steering column control module (SCCM), please follow these steps: 1.- Make sure all the switches' and airbag's harness are properly connected, disconnect the switches and reconnect them, and reverify the issue. 2.- Review the SCCM for any physical issue (Autolock, clockspring damaged) 3.- Pull the SCCM fuse for 60 sec and then reinstall it. 3.- Reverify if Steering wheel switches are inoperative. If there are no DTC's, physical defects, nor switches inop, then SCCM does not need to be replaced.
full bulletin at NHTSA ↗Source: NHTSA manufacturer communications. Bring the bulletin number to your dealer or shop.
Took delivery of new truck (2024 Ram 1500 4x4 Laramie) on September 25th. On September 26th, while backing into a parking space, the engine cut off and multiple error lights illuminated (including check engine light). I was able to re-start the vehicle and back into the space. Dealer investigated, determined that a fuse was loose. On October 14th, while pulling into a shopping center road, the…
It's a meaningful issue. 5 complaints have been filed and the failure mode causes operational problems for owners. Repairs average $700.
Mileage data is limited for this issue. Owners report failures across a wide range, suggesting cause is more about driving conditions and maintenance than mileage alone.
Independent shops typically charge around $700 for steering repairs on this vehicle. Dealer pricing tends to run 20-40% higher. The exact figure depends on the specific failure mode, parts availability, and your local labor rates. If you're outside factory warranty, an extended service contract often covers this category.
Yes — 1 active recall(s) cover steering issues on this vehicle. Recall fixes are always free regardless of mileage or warranty status. Use the VIN decoder at the top of the page to check if your specific vehicle is affected.