2026 GMC Sierra owner complaints

I do not have an official communication from the dealer who is servicing my vehicle. However, they have had my vehicle for almost 3 weeks and they tell me that the engine has failed and needs complete replacement. They said the engine lost compression and quit running, it now cranks and does not start. Although the engine has not been disassembled we believe the point fo failure to be in the rotating assembly of the bottom end of the engine.

Sudden catastrophic engine failure with only 6000 miles on vehicle on May 26, 2026. 2026 GMC Sierra 1500 AT4X with known defective 6.2L L87 V8. Had to coast across three lanes of traffic to get to other median as highway location was on large curve. Someone very easily could have been hurt or killed.

My motor has a catastrophic failure. Started sputtering and Squealing.

2026 GMC Sierra 1500 AT4X with 3898 miles. Driving 71mph on state highway on flat grade road. Lost power and vehicle shut down after pulling off the road. No previous lights or warning signs prior to power loss. Vehicle would not start afterwards. OnStar Diagnostics sent ECM Engine and Transmission System code P0016. Had vehicle towed 100miles to GM dealership. Upon inspection of vehicle, the Service Department contacted me the following day and said the the vehicle needed an entire engine replacement according to GM cooperate. I asked if it had anything to do with the 6.2L V8 L87 engine problems from previous recall years of 2021-2024. Service tech stated yes it was more than likely the same issue. Very unhappy with my new GM vehicle purchase. Will have to have a full engine replacement

I was driving on interstate 95 at approximately 70 to 75 mph when I lost all power and compromise steering with tractor trailer behind me God willing I was able to pull over to the shoulder. My safety was compromised and I lost all faith in Gmc. My vehicle has been out of service for 27 days at this point while waiting for an engine replacement with no ETA on service. According to Pennsylvania lemon law after 30 days a lemon law claim can be submitted

The contact owns a 2026 GMC Sierra 1500. The contact stated that while driving at an undisclosed speed, there was an abnormally loud and rough knocking sound coming from the engine block. The oil pressure decreased to zero, and the engine seized. There was no warning light illuminated before or after the failure. The vehicle was towed to a dealer, where it was diagnosed with a blown engine. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 5,018.

Total engine failure on 5/31/26. Truck lost engine power while on highway and had to be towed to dealership where they found the lower end of the engine failed. Engine and radiator replacement needed, both are backordered with no eta.

I bought a brand new 2026 1500 GMC sierra AT4X and after 1,800 miles the engine seized and failed.

While driving approximately 45 MPH, I slowed to make a right turn into a parking lot. The engine suddenly stalled and lost all propulsion. The vehicle retained electrical power but automatically shifted into NEUTRAL, and would not shift back into DRIVE. I braked to a stop, temporarily stranding the vehicle and blocking traffic in the parking area. Attempting to turn the vehicle off via the START/STOP button actually restarted the engine, confirming the stall. The truck then shifted into DRIVE and operated normally. A subsequent OnStar diagnostic scan found no active trouble codes.

Heard clanging noise under hood as I was driving and truck just stopped. Tried to restart and nothing! Towed to dealership where they found the engine has to be replaced.

I saw the report regarding models of Chevrolet trucks not receiving owners manuals from factory. I purchased a 2026 GMC AT4 in early October 2025. It didn't come with a manual either. I emailed my sales person at Ewing GMC in Plano, Texas informing him that it was missing the manual and I was told that GM had decided to only include physical manuals with Denali grade trucks. This didn't make any sense whatsoever. I would prefer to have a physical manual available to reference in the event of vehicle issues.

Ac not working properly. Ac blows air to defrost vents foging front windshield and side windows causing bad visibility

I bought my 2026 GMC in April. Several times the audio doesn't work work. When this happens audio related safety technology is affected too including turn signal sounds and back camera audio also. A person walking behind the truck can be seen on the screen but no warning beeps are heard. When backing up the warning for getting too close to an object also doesn't work. I called the dealer in early May and was told that this was a known issue and that it needed a software update. took the truck to the dealer on May 8th and the software update was performed. When the update had been completed when I started the truck after the update there was no audio. I told the service advisor it was currently happening and she took it back to the technician. They disconnected the battery cables to

Traveling home the day I purchased vehicle going through [XXX] with cruise set on 35,negotiating a right handed curve in the road and a vehicle was stopped in center lane turning left and my vehicle abruptly braked causing the vehicles behind me to take evasive action to keep from hitting me from behind INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

In early June 2026 I discovered a sheared pin on the front control arm of my 2026 GMC Sierra 1500 AT4X (VIN [XXX]), sold to me new by Parks GMC, Kernersville NC, with a dealer-installed Performance Package modifying the factory suspension. I delivered the truck to Parks GMC for warranty repair. The dealer represented it as a 1-2 day job. The truck was out of service approximately 2 weeks. The dealer sub-contracted the work to a third-party shop (CCV). At pickup, the dealer provided written documentation stating the repair was NOT PERFORMED. Neither the dealer nor I has been able to obtain any documentation from CCV describing what, if anything, was actually done to the vehicle. THREE UNRESOLVED SAFETY CONDITIONS: SHEARED FRONT CONTROL ARM PIN — original failure, status of repair unknown

While driving on the highway, the steering became much more stiff, and then I heard metallic clanging sounds for a few seconds. The dashboard said press start to start Vehicle. I pressed start while going 30 miles an hour and all lights and instrument clusters went black. I pulled into the grass median where the truck would not start or shift gears. Truck was towed to a GMC dealership

My 2026 GMC 1500 is equipped with the 2.7L L3B & 8L90 Transmission. At approximately 1000 miles, I noticed that in 2nd between 2700-3200 RPM, a vibration could be felt throughout the cabin and would occur whether with or without throttle application. I am able to recreate the issue during hard acceleration or placing in manual mode. No matter the Vehicle mode selection (sport, normal, snow, tow/haul, etc.), the issue still persists. I took the vehicle to a local GMC dealer at approximately 6K miles to diagnose. I requested that we test drive another 1500 with the same 2.7L and Transmission. They brought out a 2026 Elevation Quad Cab with the 2.7L; less than 20 miles on the odometer.The same vibration was present in 2nd gear at same RPM band. I requested that the issue be escalated to a loc

The contact owns a 2026 GMC Sierra 1500. The contact stated that upon starting the vehicle and shifting into reverse(R), the vehicle failed to move while depressing the accelerator pedal. The contact felt a hesitation while depressing the brake and accelerator pedals, and the contact then attempted to restart the vehicle. The contact restarted the vehicl;e however, while attempting to accelerate, the brakes independently activated. Despite the repeated failure, the contact was able to pull into a gas station to restart the vehicle. The contact stated that after several attempts, the vehicle finally resumed normal operation, and the contact drove the vehicle to the residence. The next day, the contact test drove the vehicle, and the failure reoccurred while the contact was attempting to par

My 2026 GMC Sierra has an oil-canned roof from a touchless car wash because the sheet metal lacks structural rigidity. This caused the roof to buckle and caused a permanent fold in the roof of the truck. There is already documented issues for this exact problem on the newer GMC Canyons and Chevrolet Colorado mid-sized trucks. Bulletin for reference NHTSA Official TSB #23-NA-209 PDF. I leased the vehicle on 6/19/2026 and this happened on approximately 7/7/2026. The vehicle only has 1,480 miles on it as of this date.

No sound at different times. No way to reset issue. TSB issued May 14, 2026 for known issue. As of July 6, no estimate on repair. Blinkers make no sounds, Onstar can call but you cannot hear them. In event of accident, no communication.