Free. Instant. No signup. Pulls recalls and complaints for your exact vehicle.
Couldn't find that VIN. Check the digits and try again.
2007 Nissan Maxima steering problems
moderate
Owners of the 2007 Nissan Maxima have filed 7 NHTSA complaints about the steering at roughly $700 to repair (U.S. federal records, as of August 2026). Source: NHTSA Office of Defects Investigation.See steering across all vehicles →
Complaints
7
Recalls
1
Avg fix
$700
steering complaints on the Nissan Maxima, by model year
Certain passenger vehicles equipped with an 'intelligent key' fail to conform to the requirements of federal motor vehicle safety standard no
If the key is turned to the "off" position without the transmission being in the "park" position, it is possible that the steering wheel can lock when turned to the right.
Fix: Dealers will inspect and replace the steering wheel lock assembly free of charge. The recall began on december 18, 2006. Owners may contact Nissan at 1-800-647-7261.
Is there a fix? Manufacturer service bulletins
The manufacturer has issued service bulletins covering steering on this vehicle — documented
repair instructions, service campaigns, or warranty extensions sent to dealers. A TSB isn't a recall
(it's not a free safety remedy), but it's the manufacturer acknowledging the issue and how to fix it.
Service BulletinNTB08-097LSep 2023
DIAGNOSIS OF VEHICLE PULL (DRIFT) AND/OR STEERING WHEEL OFF-CENTER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
DIAGNOSIS OF VEHICLE PULL (DRIFT) AND/OR STEERING WHEEL OFF-CENTER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
SERVICE INFORMATION When servicing run flat tires or low profile tires: - Special equipment and procedures are required to avoid damage. - Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires. - TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty. - To avoid such damage, ensure that the tire changer being used and the operator of the tire changer is capable of servicing run flat and low profile tires. - Operator?s manuals for such tire changers must be followed. See this bulletin for further detail.
SERVICE INFORMATION - This bulletin is to assist you in responding to customer questions about brake operation, and provides diagnostic and repair information for each item listed, if any should occur. - Most brake incidents fall into the following categories: a. Brake Noise: A squeak, squeal, clunk, or groan that occurs when the brakes are applied or released. b. Brake Judder: A vibration that can be felt in the vehicle, steering wheel or brake pedal when the brakes are applied. c. Pedal Feel: The effort needed to operate the brakes is too high or too low. SERVICE PROCEDURE 1. Verify the condition by road testing the vehicle with the customer. 2. Determine the specific brake incident based
If YOU CONFIRM: A vehicle needs to have the brake rotors resurfaced (front or rear). ACTION: Use the ProCut PFM Series on-car brake lathe to perform brake rotor resurfacing and follow the tips listed in this bulletin. - The ProCut PFM Series brake lathe has been chosen as the approved tool for rotor resurfacing. - The ProCut PFM Series brake lathe can be ordered from TECH-MATE at 1-800-662-2001. - ProCut technical support or service can be obtained by calling 1-800-543-6618. NOTE: Brake rotors may need to be resurfaced during routine brake repair or for brake "judder" incidents. - Brake judder: A brake pedal pulsation and/or steering wheel shimmy when braking that occurs when there is too mu
Source: NHTSA manufacturer communications. Bring the bulletin number to your dealer or shop.
What owners are reporting
0 most recent
Had steering trouble with your 2007 Nissan Maxima?
File a complaint with NHTSA → It's free, official, and how every report above got here — owner filings are the federal safety record this page is built on.
Common questions
How serious is the steering problem on the 2007 Nissan Maxima?
It's a documented issue but not catastrophic. 7 complaints have been filed. Repairs average $700 and most owners catch it before it causes a breakdown.
At what mileage does the steering typically fail?
Based on the 7 complaints filed, steering issues most often appear around 107,800 miles. Some report problems earlier; some make it well past 150,000 with no symptoms. Maintenance habits matter — vehicles that received timely fluid services and were not regularly overworked tend to last longer.
What does it cost to fix?
Independent shops typically charge around $700 for steering repairs on this vehicle. Dealer pricing tends to run 20-40% higher. The exact figure depends on the specific failure mode, parts availability, and your local labor rates. If you're outside factory warranty, an extended service contract often covers this category.
Are there any recalls related to steering?
Yes — 1 active recall(s) cover steering issues on this vehicle. Recall fixes are always free regardless of mileage or warranty status. Use the VIN decoder at the top of the page to check if your specific vehicle is affected.
Complaint and recall data sourced from the National Highway Traffic Safety Administration (NHTSA)
public records database. Verify the raw federal record at
nhtsa.gov/vehicle/2007/Nissan/Maxima.
Severity ratings are derived from reported crashes, fires, injuries, and fatalities. Repair cost estimates are
independent-shop national averages and may differ in your area. Some links on this page are affiliate links.