SWITCH - CLUTCH STARTER INTERLOCK & MASTER CYLINDER ASSEMBLY - CLUTCH
full bulletin at NHTSA ↗2015 Jeep Wrangler brakes problems
moderate Owners of the 2015 Jeep Wrangler have filed 80 NHTSA complaints about the brakes, typically surfacing around 75,000 miles at roughly $450 to repair (U.S. federal records, as of July 2026). Source: NHTSA Office of Defects Investigation. See brakes across all vehicles →
Failure mileage
Complaints
80
Recalls
0
Avg fix
$450
| Model year | brakes complaints |
|---|---|
| 2011 Wrangler | 18 |
| 2012 Wrangler | 26 |
| 2013 Wrangler | 44 |
| 2014 Wrangler | 44 |
| 2015 Wrangler (this page) | 80 |
| 2016 Wrangler | 88 |
| 2017 Wrangler | 48 |
| 2018 Wrangler | 25 |
| 2019 Wrangler | 9 |
3crashes
1fire
What stands out
Owners have filed 80 brakes complaints with NHTSA against this vehicle, but no formal recall covers the issue — the federal record reflects what manufacturers have admitted, not everything owners are reporting.
Among the 18 model years of Jeep Wrangler in our records for brakes problems, this one ranks #2 by owner-complaint volume.
Is there a fix? Manufacturer service bulletins
The manufacturer has issued service bulletins covering brakes on this vehicle — documented repair instructions, service campaigns, or warranty extensions sent to dealers. A TSB isn't a recall (it's not a free safety remedy), but it's the manufacturer acknowledging the issue and how to fix it.
"ANTI-LOCK BRAKE MODULE (ABS) 2015 AND 2016 JK ONLY; BEFORE REPLACING THE ABS MODULE, PLEASE CALL BREANNE SCHERBATY AT CELL (586) 604-4582. IF YOU DON'T RECEIVE RESPONSE WITHIN 15 MINUTES, PLEASE CONTINUE WITH NORMAL REPAIR PROCEDURE."
full bulletin at NHTSA ↗Anti-Lock Brake Module (ABS) 2015 and 2016 JK ONLY; Before replacing the ABS module, please call Breanne Scherbaty at cell (586) 604-4582. If you don't receive response within 15 minutes, please continue with normal repair procedure.
full bulletin at NHTSA ↗Wheel Speed Sensors For Jeep Wrangler (JK) only. Before replacing the wheel speed sensors, please check for wiring/connection to the speed sensor. If the sensor is replaced, record the fault codes and note any damage to the sensor.~
full bulletin at NHTSA ↗Part Description: Wheel Speed Sensors Issue Description: Before replacing the front wheel speed sensors, please call Gurdial Dhami at cell (226) 346-7919. If you do not receive a return call after 15 minutes, please proceed with repair.
full bulletin at NHTSA ↗Source: NHTSA manufacturer communications. Bring the bulletin number to your dealer or shop.
The failure pattern owners describe
The 2015 Jeep Wrangler brake complaints cluster around two primary failure patterns that owners describe as safety hazards.
ABS module failures dominate the narrative. Owners report the ABS warning light illuminating, often accompanied by traction control and brake warning lights, with diagnostic code C2200 indicating internal module failure. Symptoms include loss of anti-lock braking and traction control function, cruise control becoming inoperable, vehicle entering "limp mode" with speed limited to 15–30 mph, and in several cases, erratic brake application causing steering problems, vibrations, or burning rubber odor from rear brakes. The critical issue owners cite is that the replacement part (Mopar 68259556AD) has been on national backorder for years with no timeline for availability. Dealers repeatedly tell owners the part is unavailable, discontinued, or under "engineering review." Some owners report waiting 12–18+ months with cancelled orders and no resolution. Multiple owners note this affects thousands of vehicles nationwide and should trigger a recall.
Caliper and brake system failures appear in fewer but more acute incidents. One owner's daughter experienced a sinking brake pedal diagnosed as caliper freeze-up; a dealership repair lost a caliper bolt during reinstallation, leaving the caliper flopping loose. Another owner reported complete brake failure at a traffic light with the vehicle not responding to multiple full pedal applications and grinding noise; the dealership found no problem. A third experienced brake failure while slowing at low speed, resulting in a collision. One narrative describes a fire originating from the wheel wells and hood. Owners report grinding, scraping noises, pedal sinking, and loss of braking response under both highway and low-speed conditions.
Same Jeep Wrangler brakes reports on nearby years: 2013 · 2014 · 2016 · 2017 · 2018
Failure modes owners describe
ABS Module Internal Failure
ABS control module fails with diagnostic code C2200, disabling anti-lock braking and traction control. Owners report widespread backorder of replacement part (Mopar 68259556AD) with no availability timeline. Part described as discontinued or under indefinite 'engineering review.' Multiple owners cite waiting 12–18+ months with cancelled orders.
When: Mileage ranges from 25,400 to 145,000 miles; failures reported from 2022 through 2025
Symptoms owners cite: ABS warning light illuminated; Traction control warning light illuminated; Brake warning light illuminated; Cruise control inoperable; Vehicle enters 'limp mode' with speed capped at 15–30 mph; Erratic brake application to unnecessary wheels; Steering problems and vibrations in all four wheels; Loss of stability control
Codes mentioned: C2200
Repairs/costs cited: Replacement part Mopar 68259556AD required but unavailable nationally on extended backorder; no timeline provided for availability. Some owners mention fraudulent rebuild services. Estimated cost $1,800 mentioned by one owner for new part.
Recalls/TSBs owners mention: Chrysler/Stellantis has not issued recall. Part placed under 'engineering hold' or 'engineering review' with no stated resolution. Dealers report part discontinued or on indefinite backorder. Manufacturer has not provided alternative repair solutions or loaner vehicles.
Caliper Freeze-up and Caliper Bolt Failure
Calipers freeze, causing brake pedal to sink intermittently to the floor. During dealership repair, caliper bolt head broke during reinstallation; dealership installed replacement but failed to bleed brakes properly. Caliper was found loose and flopping on rotor after test drives, creating grinding/scraping noise and safety hazard.
When: Repair visit June 2025; caliper issue pre-existing at time of service
Symptoms owners cite: Brake pedal sinking to floor intermittently; Grinding and scraping noise from front brakes; Caliper loose and flopping on rotor
Repairs/costs cited: Dealership service failed to complete repair properly; lost caliper bolt during reinstallation and did not bleed brakes after repair. Independent mechanic corrected bolt installation and bled brakes. Owner also reported front axle seal leak and defective tie rod discovered during independent inspection.
Complete Brake Failure
Brake pedal does not respond; vehicle does not slow or stop despite multiple full pedal applications. Grinding noise heard during brake application. Vehicle enters intersection against traffic light.
When: Wet road conditions; one incident reported at traffic signal
Symptoms owners cite: Brake pedal unresponsive to pressure; Vehicle does not slow or stop; Loud grinding noise from brakes; ABS light illuminates after incident
Repairs/costs cited: Dealership service department could not duplicate concern and found no problem. Owner reports no resolution from manufacturer contact.
Recalls/TSBs owners mention: Dealership inspection found 'no problem.' Chrysler case manager assigned case number but made no follow-up contact. Manufacturer did not respond to owner's phone messages or written detailed report.
Brake System Fire
While driving at low speed, owner reported smoke smell, then brakes failed completely, followed by flames erupting from wheel wells and hood. Fire department required to extinguish.
When: Saturday morning, approximately 4.9 miles into drive
Symptoms owners cite: Smoke smell; Complete loss of brakes; Flames from wheel wells and hood; Fire requiring fire department response
Repairs/costs cited: No repair information provided; vehicle destroyed by fire.
Low-Speed Brake Failure with Collision
While slowing from very low speed on city street, brakes failed completely with pedal to floor; vehicle appeared to accelerate slightly with possible ABS activation/release; resulted in collision with stopped vehicle in front.
When: Low-speed slowing on paved city street
Symptoms owners cite: Brake failure with pedal to floor; Vehicle acceleration during brake attempt; Possible ABS activation/release; Collision with stopped vehicle
Repairs/costs cited: Owner unable to recreate malfunction after collision. No detailed diagnostic information provided.
Erratic Brake Application from Failed Brake Module
While driving, brake caution light illuminated and brakes were erroneously applied without driver input, causing slight speed reduction. Burning rubber odor came from rear of vehicle.
When: At 75,000 miles; multiple occasions during operation
Symptoms owners cite: Brake caution light illuminated; Unexpected brake application without pedal input; Burning rubber odor from rear of vehicle; Reduced vehicle speed without driver action
Repairs/costs cited: Cause of failure not determined. No repair completed.
Recalls/TSBs owners mention: Neither local dealer nor manufacturer were notified of failure.
Synthesized from 80 NHTSA owner complaints — unverified consumer allegations, summarized for patterns. The verbatim filings appear below.
What owners are reporting 0 most recent
Had brakes trouble with your 2015 Jeep Wrangler?
File a complaint with NHTSA → It's free, official, and how every report above got here — owner filings are the federal safety record this page is built on.
Common questions
How serious is the brakes problem on the 2015 Jeep Wrangler?
It's a documented issue but not catastrophic. 80 complaints have been filed. Repairs average $450 and most owners catch it before it causes a breakdown.
At what mileage does the brakes typically fail?
Across the 16 complaints that reported odometer mileage, most brakes failures cluster between 43,000 and 104,734 miles, with the median around 75,000. A quarter of owners report trouble before 43,000; a quarter make it past 104,734. Maintenance history matters more than the odometer alone — this is the reported failure window, not a guarantee.
What does it cost to fix?
Independent shops typically charge around $450 for brakes repairs on this vehicle. Dealer pricing tends to run 20-40% higher. The exact figure depends on the specific failure mode, parts availability, and your local labor rates. If you're outside factory warranty, an extended service contract often covers this category.
Are there any recalls related to brakes?
No active recalls currently cover brakes issues on this vehicle. The complaints filed represent owner-reported failures that haven't risen to the level of a manufacturer-issued recall — but they're still worth knowing about before you buy or budget for repairs.
Related
Complaint and recall data sourced from the National Highway Traffic Safety Administration (NHTSA)
public records database. Verify the raw federal record at
nhtsa.gov/vehicle/2015/Jeep/Wrangler.
Severity ratings are derived from reported crashes, fires, injuries, and fatalities. Repair cost estimates are
independent-shop national averages and may differ in your area. Some links on this page are affiliate links.