Some 2015-2021 Ford and Lincoln vehicles may exhibit an illuminated MIL with diagnostic trouble codes (DTCs) P0011, P0012, P0014, P0015, P0016, P0017, P0018, P0019, P0021, P0022, P0024 and/or P0025. Pinpoint test HK in the Powertrain Control and Emissions Diagnosis (PC/ED) or in Section 303-14 of the Workshop Manual (WSM) has been updated to address this concern.
full bulletin at NHTSA ↗2018 Ford Taurus powertrain problems
moderate Owners of the 2018 Ford Taurus have filed 5 NHTSA complaints about the powertrain at roughly $2,500 to repair (U.S. federal records, as of August 2026). Source: NHTSA Office of Defects Investigation. See powertrain across all vehicles →
| Model year | powertrain complaints |
|---|---|
| 2014 Taurus | 11 |
| 2015 Taurus | 14 |
| 2016 Taurus | 3 |
| 2018 Taurus (this page) | 5 |
Is there a fix? Manufacturer service bulletins
The manufacturer has issued service bulletins covering powertrain on this vehicle — documented repair instructions, service campaigns, or warranty extensions sent to dealers. A TSB isn't a recall (it's not a free safety remedy), but it's the manufacturer acknowledging the issue and how to fix it.
During service and repair requiring removal and replacement of a crankshaft bolt and/or crankshaft damper, achieving proper torque of the crankshaft pulley bolt is critical. Incorrect torque may allow the bolt to loosen resulting in the timing gear breaking and engine damage. Replacement of the bolt is critical to the repair and accurately following the installation procedure in the Workshop Manual (WSM) Section, 303-01 is extremely important. The bolt torque procedure can be found in the crankshaft front seal removal and installation procedure or in the engine assembly procedure.
full bulletin at NHTSA ↗Some 2015-2020 Ford and Lincoln vehicles may exhibit an illuminated MIL with diagnostic trouble codes (DTCs) P0011, P0012, P0014, P0015, P0016, P0017, P0018, P0019, P0021, P0022, P0024 and/or P0025. This may be due to small debris causing the VCT solenoid to stick. Before attempting any component diagnosis or replacement of the VCT solenoid, refer to Powertrain Control and Emissions Diagnosis (PC/ED) pinpoint test HK11 to cycle the affected VCT solenoid 10 times to attempt to clear the debris. For claiming, use causal part 6M280 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual.
full bulletin at NHTSA ↗Some 2018-2019 Explorer/Flex/Taurus/MKT vehicles equipped with a 3.5L EcoBoost engine may exhibit an illuminated malfunction indicator lamp (MIL), powertrain malfunction (wrench) lamp, Service AdvanceTrac message, Hill Start Assist Not Available message, and/or lack of power with diagnostic trouble codes (DTCs) P0107, P0108 and/or P0109 present. This may be due to a faulty manifold absolute pressure and temperature (MAPT) sensor. To correct the condition, follow the Service Procedure steps to diagnose and replace the MAPT sensor.
full bulletin at NHTSA ↗On vehicles equipped with an automatic transmission it is imperative that the converter pilot hub be greased with Motorcraft Multi-Purpose Grease Spray XL-5-A even if grease was not applied from the factory. Also verify that the engine/transmission alignment dowel pins are present as well as the engine crankshaft dowel pin, if equipped, when installing the transmission. Failure to adequately lubricate the converter hub greatly increases the likelihood of the flexplate cracking in the future. Missing dowels may cause a misalignment issue also resulting in a premature failure. Refer to Workshop Manual (WSM), Section 307-01.
full bulletin at NHTSA ↗Source: NHTSA manufacturer communications. Bring the bulletin number to your dealer or shop.
What owners are reporting 2 most recent
After exiting thruway after driving 10-15 minutes, car shuts off at a stop sign/traffic light. notice on screen right hand side state transmission not in park. I put car into park then restart vehicle. This has happened three times in last 6 months. Taken to dealer and they cannot reproduce problem or when scanned, no problem shows up.
The contact owns a 2018 Ford Taurus. The contact stated while reversing from a parking spot, the vehicle began to jerk and hesitate. The contact stated no warning light was illuminated. The contact was able to drive to her destination. The contact continued to experience the failure. The contact took the vehicle to the local dealer and made them aware of the failure. The vehicle was not repaired.…
Common questions
How serious is the powertrain problem on the 2018 Ford Taurus?
It's a documented issue but not catastrophic. 5 complaints have been filed. Repairs average $2,500 and most owners catch it before it causes a breakdown.
At what mileage does the powertrain typically fail?
Based on the 5 complaints filed, powertrain issues most often appear around 67,500 miles. Some report problems earlier; some make it well past 150,000 with no symptoms. Maintenance habits matter — vehicles that received timely fluid services and were not regularly overworked tend to last longer.
What does it cost to fix?
Independent shops typically charge around $2,500 for powertrain repairs on this vehicle. Dealer pricing tends to run 20-40% higher. The exact figure depends on the specific failure mode, parts availability, and your local labor rates. If you're outside factory warranty, an extended service contract often covers this category.
Are there any recalls related to powertrain?
No active recalls currently cover powertrain issues on this vehicle. The complaints filed represent owner-reported failures that haven't risen to the level of a manufacturer-issued recall — but they're still worth knowing about before you buy or budget for repairs.