2025 Nissan Rogue electrical problems

*****Dealer Announcement***** Nissan is conducting a service campaign on certain model year 2025 Nissan Rogue vehicles identified in Service Comm and National Service History – Open Campaigns. On affected vehicles, some NissanConnect Services subscribers are unable to access the remote engine start/stop and climate (RES) features via both the mobile app and the web portal. Customers are still able to use the key fob to remotely start their vehicle. To restore NissanConnect Services subscribers’ RES feature through the mobile app and web portal, your Nissan dealer will reconfigure the Body Control Module (BCM). *****What Dealers Should Do***** 1. Verify if vehicles are affected by this servic

VOLUNTARY SERVICE CAMPAIGN 2025 ROGUE; REMOTE ENGINE START BCM CONFIGURATION INTRODUCTION Nissan is conducting this voluntary service campaign on certain specific model year 2025 Rogue vehicles to reconfigure the BCM. This service will be performed at no charge to the customer for parts or labor. IDENTIFICATION NUMBER Nissan has assigned identification number PD175 to this campaign. This number must appear on all communication and documentation of any nature dealing with this campaign. DEALER RESPONSIBILITY Dealers are to repair vehicles falling within range of this campaign that enter the service department. This includes vehicles purchased from private parties, vehicles presented by transi

STEERING WHEEL SWITCH BUTTONS INOPERATIVE, STICKING, OR NOT CLICKING WHEN PRESSED IF YOU CONFIRM The customer states that any of the steering wheel switch buttons are inoperative, sticking, or not clicking when pressed. ACTION Follow the SERVICE PROCEDURE to: 1. Remove the steering wheel assembly. 2. Replace the switch assembly on the steering wheel assembly. HINT: The switch assembly includes switches for both sides of the steering wheel. 3. Reinstall the steering wheel assembly. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successf

MIL ON WITH DTC P0196 STORED IN THE ECM IF YOU CONFIRM The MIL is ON with DTC P0196 for “EOT SENSOR” stored in the ECM. HINT: DTC P0012 for “INTAKE VALVE TIMING CONTROL B1” may be stored along with P0196 for “EOT SENSOR”. ACTION Follow the SERVICE PROCEDURE in this bulletin to diagnose DTC P0196 for “EOT SENSOR”.  Disregard P0012 if stored along with P0196.  Do not follow the service information in the ESM when diagnosing P0196.  The ESM information will be updated at a later date.

INTELLIGENT AROUND VIEW MONITOR CAMERA CALIBRATION SERVICE INFORMATION If any Around View Monitor (AVM) camera (front, sides, or rear) and/or the AVM Control Module is replaced, camera calibration is required. The SERVICE PROCEDURE in this bulletin can be used in conjunction with the ESM and CONSULT 4 procedures for additional clarification when performing AVM camera calibration.  Refer to the ESM: DRIVER INFORMATION & MULTIMEDIA > AUDIO, VISUAL & NAVIGATION SYSTEM > INTELLIGENT AROUND VIEW MONITOR > BASIC INSPECTION > CALIBRATING CAMERA IMAGE (INTELLIGENT AROUND VIEW MONITOR) > WITH ProPILOT ASSIST 2.1