Rivian Automotive, LLC (Rivian) is recalling certain 2022 R1T, R1S, and EDV vehicles
A loose steering knuckle fastener could separate, causing a loss of vehicle control and increasing the risk of a crash.
Free. Instant. No signup. Pulls recalls and complaints for your exact vehicle.
Couldn't find that VIN. Check the digits and try again.
severe Owners of the 2022 Rivian R1T have filed 10 NHTSA complaints about the suspension at roughly $900 to repair (U.S. federal records, as of July 2026). Source: NHTSA Office of Defects Investigation. See suspension across all vehicles →
A loose steering knuckle fastener could separate, causing a loss of vehicle control and increasing the risk of a crash.
The manufacturer has issued service bulletins covering suspension on this vehicle — documented repair instructions, service campaigns, or warranty extensions sent to dealers. A TSB isn't a recall (it's not a free safety remedy), but it's the manufacturer acknowledging the issue and how to fix it.
Rivian is initiating a technical service bulletin for some 2022-2024 R1T and R1S vehicles. In some situations, the driver may notice a squeaking or chirping noise coming from the front of the vehicle when driving on uneven surfaces below 32 km/h (20 mph). This condition does not affect vehicle performance. Upon customer complaint of this squeaking or chirping noise, Rivian will replace the front hydraulic jounce lines with upgraded components to eliminate the noise.
full bulletin at NHTSA ↗Rivian is initiating a Preliminary Information Notification (PIN) for MY2022/23 R1 vehicles. Under certain driving conditions, at low speeds (under 25 mph), when the vehicle is articulating over bumps and uneven surfaces, a chirp noise can be heard inside the cabin, which might be perceived as a quality issue. But the noise is not an indication of a quality issue and there are no resulting performance issues with the vehicle. Rivian is currently assessing potential noise mitigations.
full bulletin at NHTSA ↗Rivian is initiating a customer satisfaction campaign for some 2022 R1T vehicles that may have been builtwith hydraulic suspension jounce lines that could contact the front underbody subframe panel and/or the front wheel liners. Over time the hydraulic suspension jounce lines may rub through due to this contact. As a result, the vehicle may experience a loss of hydraulic pressure, suspension sag, increased body roll, and/ or the vehicle may enter a reduced performance safe-state mode with limited speed. If the vehicle enters a reduced performance safe-state mode, there will be a notification displayed and a malfunction indicator lamp illuminated on the driver display. Rivian will replace the
full bulletin at NHTSA ↗Rivian is initiating a customer satisfaction campaign for some model year 2022 R1T vehicles that may have been built with front upper control arm bolt pass through holes in the shock tower that are larger than necessary. This could lead to premature wear of the control arm bushings, causing minor changes to vehicle suspension alignment. Rivian will inspect the front upper control arm bushings for wear and install washers on the front shock towers to better support the bushings. Rivian is launching this campaign for customer satisfaction and to ensure the quality of Rivian vehicles.
full bulletin at NHTSA ↗Rivian is initiating a customer satisfaction campaign for some model year 2022 R1T vehicles that may have been built with rear left-hand (LH) and/or right-hand (RH) upper lateral link fasteners that were over-torqued. Over time, this over-torquing may cause the components, including the bolt, mounting bracket and upper lateral link bushing to deform, resulting in a loose joint. The loose joint could result in a loss of wheel camber setting and a noticeable change in handling characteristics and tire wear. The customer may also notice increased noise from the rear of the vehicle. Rivian will replace both the LH and RH upper lateral links and their associated fasteners. Rivian is launching thi
full bulletin at NHTSA ↗Source: NHTSA manufacturer communications. Bring the bulletin number to your dealer or shop.
Was driving through an intersection in traffic when I heard a loud explosion/metal-on-metal sound from the front drivers side of the vehicle. Instantly received two warnings in the IP; one for "Performance Limited" and the other for "Service Suspension Soon". The IP also stated speed was limited to 80MPH. I didn't notice any difference in driving but decided to pull over and check. Upon checking…
It's a meaningful issue. 10 complaints have been filed and the failure mode causes operational problems for owners. Repairs average $900.
Mileage data is limited for this issue. Owners report failures across a wide range, suggesting cause is more about driving conditions and maintenance than mileage alone.
Independent shops typically charge around $900 for suspension repairs on this vehicle. Dealer pricing tends to run 20-40% higher. The exact figure depends on the specific failure mode, parts availability, and your local labor rates. If you're outside factory warranty, an extended service contract often covers this category.
Yes — 1 active recall(s) cover suspension issues on this vehicle. Recall fixes are always free regardless of mileage or warranty status. Use the VIN decoder at the top of the page to check if your specific vehicle is affected.