Ford Motor Company (Ford) is recalling certain 2023 Bronco Sport vehicles
A leak inside the ABS module can cause an unexpected increase in brake pedal travel or unexpected movement during an Auto Hold event, increasing the risk of a crash.
Free. Instant. No signup. Pulls recalls and complaints for your exact vehicle.
Couldn't find that VIN. Check the digits and try again.
severe Owners of the 2023 Ford Bronco Sport have filed 8 NHTSA complaints about the brakes at roughly $450 to repair (U.S. federal records, as of July 2026). Source: NHTSA Office of Defects Investigation. See brakes across all vehicles →
| Model year | brakes complaints |
|---|---|
| 2021 Bronco Sport | 94 |
| 2022 Bronco Sport | 32 |
| 2023 Bronco Sport (this page) | 8 |
A leak inside the ABS module can cause an unexpected increase in brake pedal travel or unexpected movement during an Auto Hold event, increasing the risk of a crash.
The manufacturer has issued service bulletins covering brakes on this vehicle — documented repair instructions, service campaigns, or warranty extensions sent to dealers. A TSB isn't a recall (it's not a free safety remedy), but it's the manufacturer acknowledging the issue and how to fix it.
Some 2020-2023 Escape and 2021-2023 Bronco Sport vehicles may exhibit a moan noise when the vehicle is driven in reverse (R) in cold weather and/or high humidity. This may be due to the suspension sensitivity of the vehicle. To correct this condition, follow the Service Procedure to replace the standard and reinforced rear caliper bushings and apply Kluberpaste to the machined surfaces of the brake caliper and caliper support bracket.
full bulletin at NHTSA ↗Some 2023 Escape, Corsair, Bronco Sport and Maverick vehicles built on 01-May-2023 and through 22-Sep-2023 may exhibit a squeal and/or grinding noise and/or vibration from the front brakes while braking. This may be due to excessive wheel hub lateral runout. To correct this condition, remove the front brake disc(s) of the affected wheel(s). Refer to the Workshop Manual (WSM), Section, 206-03. Clean the raised ring-like surface of the front wheel hub near the wheel studs. Using a dial indicator, slowly rotate the wheel hub and measure the runout on the ring-like surface. If the total runout exceeds 0.001 inch (0.03mm), replace the wheel hub. Refer to the WSM, Section 204-01. Document the meas
full bulletin at NHTSA ↗Some Ford and Lincoln vehicles may exhibit noise when the brakes are applied. When diagnosing and repairing brake noise conditions, use the Workshop Manual (WSM) and the appropriate pinpoint test in section 206-00. The brake rotors should only be machined if directed by the WSM because one or more of the following conditions are present on the braking surface: scoring, excessive corrosion/rust or pitting, bluing/discoloration and/or heat spots. For additional information, refer to WSM section 206-00.
full bulletin at NHTSA ↗Source: NHTSA manufacturer communications. Bring the bulletin number to your dealer or shop.
It's a meaningful issue. 8 complaints have been filed and the failure mode causes operational problems for owners. Repairs average $450.
Based on the 8 complaints filed, brakes issues most often appear around 5,750 miles. Some report problems earlier; some make it well past 150,000 with no symptoms. Maintenance habits matter — vehicles that received timely fluid services and were not regularly overworked tend to last longer.
Independent shops typically charge around $450 for brakes repairs on this vehicle. Dealer pricing tends to run 20-40% higher. The exact figure depends on the specific failure mode, parts availability, and your local labor rates. If you're outside factory warranty, an extended service contract often covers this category.
Yes — 1 active recall(s) cover brakes issues on this vehicle. Recall fixes are always free regardless of mileage or warranty status. Use the VIN decoder at the top of the page to check if your specific vehicle is affected.