SERVICE INFORMATION When servicing run flat tires or low profile tires: - Special equipment and procedures are required to avoid damage. - Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires. - TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty. - To avoid such damage, ensure that the tire changer being used and the operator of the tire changer are capable of servicing run flat and low profile tires. - Operator?s manuals for such tire changers must be followed. See this bulletin for further detail.
full bulletin at NHTSA ↗2013 INFINITI G37 steering problems
severe Owners of the 2013 INFINITI G37 have filed 3 NHTSA complaints about the steering at roughly $700 to repair (U.S. federal records, as of August 2026). Source: NHTSA Office of Defects Investigation. See steering across all vehicles →
| Model year | steering complaints |
|---|---|
| 2009 G37 | 4 |
| 2013 G37 (this page) | 3 |
When does it fail?
Of the 3 steering complaints filed for the 2013 INFINITI G37, here's the actual mileage breakdown — failures cluster heaviest at 25,000-50,000 mi.
Each bar shows the share of total complaints filed at that mileage range. Peak failure window highlighted. Some owners report problems earlier; some make it well past 150,000 miles symptom-free. Maintenance habits and driving conditions shift the curve as much as mileage alone.
No new NHTSA steering complaint has been filed on this vehicle in over 7 years — the issue may be aging out of the active population.
Is there a fix? Manufacturer service bulletins
The manufacturer has issued service bulletins covering steering on this vehicle — documented repair instructions, service campaigns, or warranty extensions sent to dealers. A TSB isn't a recall (it's not a free safety remedy), but it's the manufacturer acknowledging the issue and how to fix it.
SERVICE INFORMATION When diagnosing an applied vehicle for possible power steering gear (rack and pinion steering rack, or steering rack) leak issues, in some cases it may appear the steering rack is leaking when actually, it?s not. Use this service bulletin to help make a more accurate diagnosis of the steering rack. - Go to Power Steering Gear Inspection starting on page 2. See this bulletin for further detail.
full bulletin at NHTSA ↗If YOU CONFIRM: A vehicle needs to have the brake rotors resurfaced (front or rear). ACTION: Use the ProCut PFM Series on-car brake lathe to perform brake rotor resurfacing and follow the tips listed in this bulletin. - The ProCut PFM Series brake lathe has been chosen as the approved tool for rotor resurfacing. - The ProCut PFM Series brake lathe can be ordered from TECH-MATE at 1-800-662-2001. - ProCut technical support or service can be obtained by calling 1-800-543-6618. NOTE: Brake rotors may need to be resurfaced during routine brake repair or for brake "judder" incidents. - Brake judder: A brake pedal pulsation and/or steering wheel shimmy when braking that occurs when there is too mu
full bulletin at NHTSA ↗SERVICE INFORMATION - This bulletin is to assist you in responding to customer questions about brake operation, and provides diagnostic and repair information for each item listed, if any should occur. - Most brake issues fall into the following categories: a. Brake Noise: A squeak, squeal, clunk, or groan that occurs when the brakes are applied or released. b. Brake Judder: A vibration that can be felt in the vehicle, steering wheel, or brake pedal when the brakes are applied. c. Pedal Feel: The effort needed to operate the brakes is too high or too low. SERVICE PROCEDURE 1. Verify the condition by road testing the vehicle with the customer. 2. Determine the specific brake issue based on th
full bulletin at NHTSA ↗Source: NHTSA manufacturer communications. Bring the bulletin number to your dealer or shop.
What owners are reporting 2 most recent
Amber key light came on the vehicle's dashboard after the power lock window lights on the side of the doors started flickering and powering down while the car was in motion. Then I pulled over to an empty parking lot in the middle of the night to check the front hood of the car for any electrical fire or burning odors and then I I was unable to start the car when I turned it off and got stranded.…
I was in a parking lot. I backed out when I started to shift into drive the car accelerated and started to spin in circles. The steering wheel locked. I was not in control of the car and nothing would worked in the car. I couldn't shift gears so I shoved it into park. The car finally stopped but not before it hit an island causing $7822 in damages to the rear of the car. The air bags did not…
Common questions
How serious is the steering problem on the 2013 INFINITI G37?
It's a meaningful issue. 3 complaints have been filed and the failure mode causes operational problems for owners. Repairs average $700.
At what mileage does the steering typically fail?
Based on the 3 complaints filed, steering issues most often appear around 27,633 miles. Some report problems earlier; some make it well past 150,000 with no symptoms. Maintenance habits matter — vehicles that received timely fluid services and were not regularly overworked tend to last longer.
What does it cost to fix?
Independent shops typically charge around $700 for steering repairs on this vehicle. Dealer pricing tends to run 20-40% higher. The exact figure depends on the specific failure mode, parts availability, and your local labor rates. If you're outside factory warranty, an extended service contract often covers this category.
Are there any recalls related to steering?
No active recalls currently cover steering issues on this vehicle. The complaints filed represent owner-reported failures that haven't risen to the level of a manufacturer-issued recall — but they're still worth knowing about before you buy or budget for repairs.