Ford Motor Company (Ford) is recalling certain 2021-2024 Bronco vehicles
An external reservoir that detaches from a vehicle can create a road hazard, increasing the risk of a crash.
Free. Instant. No signup. Pulls recalls and complaints for your exact vehicle.
Couldn't find that VIN. Check the digits and try again.
moderate Owners of the 2024 Ford Bronco have filed 3 NHTSA complaints about the suspension at roughly $900 to repair (U.S. federal records, as of July 2026). Source: NHTSA Office of Defects Investigation. See suspension across all vehicles →
| Model year | suspension complaints |
|---|---|
| 2021 Bronco | 23 |
| 2022 Bronco | 26 |
| 2023 Bronco | 12 |
| 2024 Bronco (this page) | 3 |
Of the 4 model years of Ford Bronco we track for suspension problems, this one has the fewest owner complaints on file (3).
An external reservoir that detaches from a vehicle can create a road hazard, increasing the risk of a crash.
The manufacturer has issued service bulletins covering suspension on this vehicle — documented repair instructions, service campaigns, or warranty extensions sent to dealers. A TSB isn't a recall (it's not a free safety remedy), but it's the manufacturer acknowledging the issue and how to fix it.
This article supersedes TSB 24-2408 to update the parts list. Some of the vehicles listed in the Model statement above may exhibit a loud front end clink/clunk noise that leads to the identification of a cracked or broken front differential frame mount bracket. This may be due to flexing of the front differential from driving in 4L for extended periods of time. Note: Advise the customer that 4L/Rock Crawl drive mode should only be used when necessary, as using 4L when not necessary can cause damage to the vehicle. Refer to the Owner's Manual for additional information.
full bulletin at NHTSA ↗This article supersedes TSB 24-2104 to update the vehicle model years affected. Some vehicles listed in the Model statement above may exhibit a "Sta-bar Disconnect Service Required" message in the instrument panel cluster (IPC) and an illuminated warning light with any of the following diagnostic trouble codes (DTCs) stored in the chassis control module (CHCM): C103A, C1A99, C1B03, C1B07, C1B14 and/or B1A67. This may be due to water intrusion in the stabilizer bar wiring harness connector.
full bulletin at NHTSA ↗Some 2021-2024 Bronco vehicles built on or before 01-Jan-2025 equipped with a 2.3L EcoBoost engine and 10R60 automatic transmission may exhibit diagnostic trouble codes (DTCs) P0300, P0301, P0302, P0303, and P0304 and may be accompanied by a buck/jerk sensation while driving between 35-55 mph (56-89 km/h) in gears 7-10. If the condition remains after normal engine misfire diagnostics and associated repairs have been performed, the condition may be related to driveline torsional vibration induced by the rear wheels and/or rear axle assembly. The driveline torsional harmonics/vibrations are incorrectly identified by the misfire monitor as an engine misfire. Perform standard road force wheel ba
full bulletin at NHTSA ↗Source: NHTSA manufacturer communications. Bring the bulletin number to your dealer or shop.
It's a documented issue but not catastrophic. 3 complaints have been filed. Repairs average $900 and most owners catch it before it causes a breakdown.
Mileage data is limited for this issue. Owners report failures across a wide range, suggesting cause is more about driving conditions and maintenance than mileage alone.
Independent shops typically charge around $900 for suspension repairs on this vehicle. Dealer pricing tends to run 20-40% higher. The exact figure depends on the specific failure mode, parts availability, and your local labor rates. If you're outside factory warranty, an extended service contract often covers this category.
Yes — 1 active recall(s) cover suspension issues on this vehicle. Recall fixes are always free regardless of mileage or warranty status. Use the VIN decoder at the top of the page to check if your specific vehicle is affected.